Section 49 (Rear Axle - Repair)
WARNING: This page is about a different car, the 2014 BMW X6 M, 2013 BMW X6 M, 2012 BMW X6 M, 2011 BMW X6 M, and 2010 BMW X6 M. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 33 00... Information on replacing shock absorbers
- 33 00... Instructions (chassis components made of aluminum)
- 33.... Layout of shock absorber
- 33 00... Notes on repairing threads
- 33...... Overview of Dynamic Performance Control (DPC)
- 33.... Overview of rear axle support with rubber mounts
- 33.... Overview of steering links
- 00..... Raising vehicle with trolley jack
- 33.... Rear axle layout
- 33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
- 41 00... Repair solution for straight shank/hexagon rivet nut
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- Final Drive
- 00 11 259 Changing oil in rear axle final drive (Dynamic Performance Control) and disposing of used oil
- 00 11... Checking/topping up oil level in rear axle final drive (Dynamic Performance Control)
- 37 60 002 Initial operation for Dynamic Performance Control
- 33 11 694 Overview of rear axle final drive (Dynamic Performance Control)
- 33 10 016/17 Removing and installing/renewing rear axle final drive (Dynamic Performance Control)
- 33 60 003 Removing and installing/replacing control unit for Dynamic Performance Control
- 33 10... Removing and installing/replacing left or right servomotor
- 33 111400 Removing and installing/replacing vent line on rear differential (Dynamic Performance Control)
- 33 10 160 Replacing left or right temperature sensor
- 33 10 021 Replacing output shaft seal in rear axle final drive
- Final Drive With Cover
- 33 11 694 Overview of rear axle final drive (Dynamic Performance Control)
- 33 11 091 Replacing drive flange on left or right of rear axle final drive
- 33 10 021 Replacing output shaft seal in rear axle final drive
- 33 11 021 Replacing shaft seal for drive flange on rear differential (inserted propeller shaft)
- Final Drive Mounting
- Output Shafts
- Rear Sub-Frame
- Control Arms And Struts
- 33 32 125 Replacing a ball joint in lower steering stub/wheel carrier
- 33 32 131 Removing and installing/replacing a steering stub/wheel carrier
- 33 32 153 Removing and installing/replacing front compression strut
- 33 32 051 Removing and installing/replacing left or right push rod/integral link
- 33 32 064 Removing and installing/replacing left or right swinging arm
- 33 32 155 Removing and installing/replacing rear compression strut
- 33 32 091 Replacing a control arm
- 33 32 071 Replacing an upper wishbone
- Axle Mounting
- Wheel Bearings
- Shock Absorber
- Springs With Suspension
- Stabilizer Bar