Transmission Mount, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• Replace the bolts that were tightened with an additional turn.

-- Secure the transmission support to the longitudinal member.

• The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts. Push the rear of the transmission upward using a floor jack if necessary.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Position bolts by hand. While doing so, make sure that the bolts are not installed at an angle.

-- Check the adjustment of the subframe mount. Refer to ASSEMBLY MOUNT, CHECKING ADJUSTMENT .

-- Remove the Engine Support Bridge: 10-222A  from the engine.

-- Install the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .