APP Sensor Signal Inspection: Inspection

How to use this manual .

NOTICE:

Check for Pending or Confirmed DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot them first, then do this procedure.

NOTE:

This procedure checks the APP sensor in its fully closed position. In any other position, the PCM stores the APP sensor DTCs which are covered in other troubleshooting procedures.
Press the accelerator pedal several times to check its operation. If it does not operate smoothly, check the pedal. If you find a problem, replace the accelerator pedal module .

APP Sensor Signal - Inspect

Preconditions

HDS Connected

Procedure/Specifications

Select the following menu buttons on the HDS screen in sequence.
NOTICE:

Make sure the accelerator pedal is not pressed.
- PGM-FI (System Selection Menu)
- Data List
- APP Sensor

Specifications

HDS Item	Specification
APP Sensor	0 %

Result

If the measurement is not within specifications, update the PCM to the latest software - Refer to: PCM Reset or PCM Update or substitute a known-good PCM - Refer to: Air Cleaner Area(3.0L Engine) or Air Cleaner Area(2.0L Engine) , then recheck. If the recheck result is abnormal, replace the accelerator pedal module , and recheck.