Instrument Fascia Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the trim or the panels.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove these items:
- Driver's dashboard trim (see DRIVER'S DASHBOARD TRIM REMOVAL/INSTALLATION )
- Dashboard center trim, driver's side (see DASHBOARD CENTER TRIM REMOVAL/INSTALLATION )
Adjust the steering column to the full tilt down position and to the full telescopic out position.
Detach the clips and release the hooks (A) fastening the instrument fascia (B) from the upper column cover (C).

Fig 1: Identifying Hooks, Instrument Fascia And Upper Column Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Gently pull out the instrument fascia (A) to detach the clips, then remove it.

Fig 2: Identifying Instrument Fascia
Courtesy of AMERICAN HONDA MOTOR CO., INC.
install the instrument fascia in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.