LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2008 >> TL Base >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System >> Starter Solenoid Test

Starter Solenoid Test

  1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
  2. Remove the left side engine compartment cover (see step 3 on ENGINE REMOVAL ).
  3. Disconnect the negative cable from the battery.
  4. Disconnect the starter cable (A), BLK/WHT wire (B), and motor cable (C).

    M/T 

    Fig 1: Starter Cable, BLK/WHT Wire And Motor Cable - M/T Model With Torque Specifications
    G05457391Courtesy of AMERICAN HONDA MOTOR CO., INC.

    A/T 

    Fig 2: Starter Cable, BLK/WHT Wire And Motor Cable - A/T Model With Torque Specifications
    G05457392Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
    • If there is continuity, go to step 6.
    • If there is no continuity, replace the solenoid.
  6. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
    • If there is continuity, the solenoid is OK.
    • If there is no continuity, replace the solenoid.
  7. Connect the cables and wire in the reverse order of removal.
  8. Connect the negative cable to the battery.
  9. Reinstall the left side engine compartment cover (see step 82 on ENGINE INSTALLATION ).
  10. Enter the anti-theft codes for the audio system and the navigation system (if equipped).
  11. Set the clock (on vehicles without navigation).
scientia non olet · About LEMON Manuals