Front Passenger's Weight Sensor Replacement: Installation

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Be sure to install the harness wires so they are not pinched or interfering with other parts.
Make sure both of the hooks (A) on the seat track are properly secured to the front bracket (B). If the hooks are not properly secured, the front passenger's weight sensors will not function properly.

Install the new front passenger's weight sensors with tamper-resistant 6 mm TORX bolts (C) and 8 mm TORX bolts (D) under the seat track.

Fig 1: TORX Bolts With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reassemble the front passenger's seat cushion cover/pad (see FRONT SEAT CUSHION COVER REPLACEMENT ).
Reinstall the front passenger's seat (see FRONT SEAT REMOVAL/INSTALLATION ).
Reconnect the negative cable to the battery.
Calibrate the ODS unit (see ODS UNIT CALIBRATION ).
After installing the front passenger's weight sensors, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come ON for about 6 seconds and then go off.