LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2001 >> 3.2CL Base >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Automatic A/C-Heater Systems >> Component Tests >> Radiator Fan Control Module

Radiator Fan Control Module

Perform test with radiator fan control module 8-pin harness connector connected, ignition on and A/C switch OFF. See RADIATOR FAN CONTROL MODULE INPUT TESTS  . If cause of problem is discovered while performing tests, correct problem before continuing tests.

RADIATOR FAN CONTROL MODULE INPUT TESTS

Pin No. (Wire Color) Test Condition Desired Results
1 (Yellow) Check For Battery Voltage (1) Battery Voltage
2 (Black/Yellow) Check For Battery Voltage (2) Battery Voltage
3 (Yellow/White) Check For Battery Voltage (1) Battery Voltage
4 (Black) Check For Continuity To Ground (3) Less Than One Volt
5 (White/Green) Check For Continuity To Ground (4) Less Tnan One Volt
6 (White/Red) Check For Battery Voltage (5) Battery Voltage
7 (Black/Yellow) Check For Battery Voltage (6) Battery Voltage
8 (Green) Connected To Body Ground (7) Condenser Fan & Radiator Fan Run
(1) Replace radiator fan control module. Before replacing module, check continuity between condenser fan relay Yellow/White wire and ground, and radiator fan relay Yellow wire and ground. Continuity should not exist.
(2) Check fuse No. 3 (7.5-amp) in underdash fuse/relay block. If fuse is okay, repair open in Black/Yellow wire.
(3) Repair open to ground.
(4) Repair short to ground, faulty radiator fan switch "B", or faulty radiator fan control module.
(5) Check fuse No. 54 (40-amp) in underhood fuse/relay box. Check fuse No. 13 (15-amp) in passenger's under-dash fuse/relay box. If fuse is okay, repair open in White/Red wire.
(6) Check fuse No. 6 (15-amp) in underdash fuse/relay box. If fuse is okay, repair open in Black/Yellow wire.
(7) Check for an open in Green wire between radiator fan control module, condenser fan relay and radiator fan relay. If wire is okay, check for open Yellow/White wire between radiator fan control module and condenser fan relay, or open Yellow wire between radiator fan control module and radiator fan relay. If wires are okay, test condenser fan relay and radiator fan relay. See RELAYS  under TESTING.