TPMS Reminder Reset - Procedure 01
Tire Pressure Warning
There are two warning levels that generate different warning messages, one warning for low pressure and a warning for very low pressure. A message is also displayed if a sensor stops transmitting or receives insufficient battery voltage. A warning lamp also lights in the Driver information module (DIM) at the same time as the warning message appears.
The easiest way to reset a warning is to fill the underinflated tire to specification. The warning in the Driver information module (DIM) disappears the next time the ignition is switched on. If air is filled in a tire that has warned of low pressure and the ignition is on during the entire process, the warning will go out as soon as the pressure in the tire exceeds the specified level.
Tire Sensor Learning
If a sensor must be replaced, the system must "learn" the new sensor ID. This can be carried out in 2 different ways:
- Drive the vehicle faster than 25 mph (40 km/h) for longer than 10 minutes. The warning for low pressure remains in the Driver information module (DIM) until the Central electronic module (CEM) has identified the new sensor.
- Programming "by hand". This is carried out using the appropriate Volvo tire sensor activation tool, or Low Frequency (LF) initiator (sensor activation tool). Activating the tire pressure sensors this way replaces driving.NOTE: The Volvo tire sensor activation tool does not work with the sensors on S40 (04-)/ V50/ C30/ C70 (06-)