LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2017 >> V90 T6 R-Design >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Monitor Reset

Tire Pressure Monitor Reset

  1. Switch off the engine.
  2. Inflate the tires to the desired pressure and START THE ENGINE.
  3. Open the CAR STATUS app in the center display's App view.
  4. Tap STATUS to access Tire Pressure Monitoring System.
  5. Tap the CALIBRATION button.
  6. Tap OK after the tire pressure in all four tires has been checked and adjusted.
  7. Drive the vehicle. Calibration is done when the vehicle is driving at a speed above 35 km/h (22 mph).
NOTE: If the car's ignition is switched off before calibration is complete, the tires in the center display change color from gray to green upon next start-up, even if calibration is not complete. Perform the calibration again and allow it to complete within the same operating cycle to ensure that the calibration is carried out correctly. When enough data has been collected for the system to detect low tire pressure, the color of the tire symbols in the center display will change from gray to green. The system will not provide any other confirmation that calibration has been completed. If start-up of calibration fails, the following message appears: Calibration Unsuccessful. Try again. 
scientia non olet · About LEMON Manuals