Service Menu For Changing Power Mode

There are three different POWER-mode in the system that define how the system is to interact in switching the system ON/off. The system is set to OFF as default, and this should not be changed unless requested by the customer.

Short description of the various POWER-mode : 

• ON   : The DVD device is automatically activated when the ignition is switched on.
• OFF   : The DVD device is automatically set to standby mode the next time the ignition is switched on after the power has been cut.
• LAST MEM.   : The DVD device is automatically activated if, in the last operating cycle, it was activated, and deactivated if, in the last operating cycle, it was deactivated, the next time the ignition is switched on.

Do as follows to open the menu for changing POWER-mode : 

1. Turn on the ignition.
2. Activating the system for rear seat entertainment.
   NOTE:

   There must not be a disc in the DVD player.

3. Press DRIVER   or PASSENGER   on the remote control depending on which DVD device is to be coded.
   NOTE:

   Ensure that only the DVD unit to be coded is active.

4. Point the remote control at the DVD device to be coded and press the following sequence: UP  , RIGHT  , LEFT  , DOWN  and then ENT   .
5. Select the applicable coding for the relevant DVD device by scrolling the menu with the RIGHT  arrow. Then press PIC MENU   to confirm and exit the menu.
6. Deactivating the system for rear seat entertainment.