Checking Components And Wiring

Check the cable between control module terminal #12 and water pump terminal 1. Check for a short-circuit to supply voltage.

The water pump must be replaced if no faults are found in the cable.

Remedy as necessary.

Other information:

To access the control module or connect the breakout box, see CONNECTING THE BREAKOUT BOX
To access or replace the water pump, see WATER PUMP ENGINE COOLANT HEATER, REPLACING
With the ignition on and the water pump connector disconnected, the voltage between water pump terminal 1 (control module side) and ground should be approximately 0 V
For other values, see SIGNAL SPECIFICATION
see CHECKING WIRING AND TERMINALS .

Fig 1: Identifying 2-Pin Connector

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying Connector Terminals

Courtesy of VOLVO CARS CORPORATION