| Handling |
Expected result |
Remarks |
| Insert the key and turn on the ignition. |
RSE in standby mode, power-button lights up. |
The RSE-system has a "last memory handling", that is, if the monitor was down the last time the vehicle was turned off, the monitor will be lowered when the ignition is activated again. |
| Activate RSE by pressing on the power-button. |
The monitor is lowered and remaining buttons on the control panel light up. |
|
| Engage reverse. |
The monitor comes up. |
The signal comes from the left back-up light. |
| Disengage reverse. |
The monitor goes down. |
|
| Remove the key. |
The dialogue box on the monitor shows: "CHOOSE YES TO CONTINUE 1 HOUR" |
|
| Choose "NO". |
The RSE-system is inactivated and the monitor is lowered. |
|
| Insert the key again and turn on the ignition. |
The RSE-system is activated and the monitor is lowered. |
|
| Turn off the system with the power-button. |
The monitor comes up again. |
This is only done so that the system shall be in stand-by the next time that the ignition is turned on. |
| Remove the key. |
The RSE-system is inactivated. |
|