Checking The Contact Reel

Check that the upper connector on the switch for the cruise control is correctly connected.

Disconnect the upper switch on the switch for the cruise control. Take voltage readings between terminals #B1 (26) and #B3 (28) (on the cable connector). The fault is probably in the contact reel if the voltage is 0 V. The fault is probably in the switch for the cruise control if the voltage is approximately 12 V.

Remedy as necessary.

Other information: 

• To access or replace the cruise control switch, see KEYPAD STEERING WHEEL, REPLACING
• To replace the contact reel, see CONTACT REEL, REPLACEMENT
• To access or replace the steering wheel module (SWM), see STEERING WHEEL MODULE (SWM), REPLACING
• To connect the breakout box, see CONNECTING THE BREAKOUT BOX .

Fig 1: Breakout Box

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Voltage Display

Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION