Checking Components And Wiring

Check the resistance of the clutch pedal sensor between terminals #2 and #4 (component side).

Check the signal cable between engine control module (ECM) terminal #B15 (#B25) and clutch pedal sensor terminal #2 (wiring side). Check for a short-circuit to ground.

HINT: With the ignition on, the power supply to the clutch pedal sensor must be approximately 5 V (measured with the clutch pedal sensor disconnected), measured between terminals #2 and #4 (wiring side). 

Remedy as necessary.

Other information: 

• see CHECKING WIRING AND TERMINALS
• To connect the breakout box, see CONNECTING THE BREAKOUT BOX
• To access or replace the clutch pedal sensor, see PEDAL POSITION SENSOR CLUTCH, REPLACING
• For resistance values, see COMPONENT SPECIFICATIONS
• For 5 cylinder turbocharged engines -2004, see SIGNAL DESCRIPTION
• For 5 cylinder turbocharged engines 2005-, see SIGNAL SPECIFICATION .
• For 6 cylinder engines -2004, see SIGNAL SPECIFICATION
• For 6 cylinder engines 2005-, see SIGNAL SPECIFICATION .

Fig 2: 10 CD Changer Connector Terminals

Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying Ohm Meter

Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Clutch Pedal Push Rod & Position Sensor

Courtesy of VOLVO CARS CORPORATION

Refer to VERIFICATION