Checking Components And Wiring
Check the signal cable between knock sensor (KS) terminal #1 and control module terminal #A46 (#A46). Check the ground lead between knock sensor (KS) terminal #2 and control module terminal #A64 (#B4). Check for a short-circuit to supply voltage.
Check that the knock sensor (KS) is tightened to the correct torque.
HINT: The diagnostic trouble code (DTC) may be caused by a worn engine. Start the engine and listen for noise.
Remedy as necessary.
Other information
- To connect the breakout box / access the control module, see CONNECTING THE BREAKOUT BOX
- To access or replace the knock sensor (KS), see KNOCK SENSOR (KS), REPLACING
- For 5 cylinder turbocharged engines -2004, see SIGNAL DESCRIPTION
- For 5 cylinder turbocharged engines 2005-, see SIGNAL SPECIFICATION .
- see CHECKING WIRING AND TERMINALS
- Continue
Refer to VERIFICATION