Checking Components And Connectors
Check the camshaft position (CMP) sensor and control module connectors. Check for contact resistance and oxidation.
Check that the camshaft position (CMP) sensor is correctly installed and that neither the sensor or the housing is damaged. Damage may affect the position of the sensor in relation to the camshaft rotor.
Try a new camshaft position (CMP) sensor if no fault is found during the above fault-tracing.
Remedy as necessary.
Other information
- To connect the breakout box / access the control module, see CONNECTING THE BREAKOUT BOX
- For the location of components in the engine compartment, see LOCATION OF COMPONENTS, ENGINE COMPARTMENT
- For 5 cylinder turbocharged engines -2004, see SIGNAL DESCRIPTION
- For 5 cylinder turbocharged engines 2005-, see SIGNAL SPECIFICATION .
- For 6 cylinder engines -2004, see SIGNAL SPECIFICATION
- For 6 cylinder engines 2005-, see SIGNAL SPECIFICATION .
- see CHECKING WIRING AND TERMINALS .
- Continue
Refer to VERIFICATION