Checking Components
Check that the fuel level in the tank is not too low (almost no fuel).
Check the connectors between the pump control module and the fuel pump (FP). Check for contact resistance and oxidation.
Check the fuel lines and fuel filter for blockage and leaks.
Remedy as necessary.
Try a new fuel pump (FP) if no fault is found during the above fault-tracing.
HINT: The diagnostic trouble code (DTC) can also be caused by a defective pump control module.
Other information:
- see CHECKING WIRING AND TERMINALS
- To access or replace the fuel pump (FP), see LEVEL SENSOR, FUEL TANK/FUEL PUMP, REPLACEMENT
- To access or replace the pump control module, see CONTROL MODULE FUEL PUMP (FP), REPLACING .
- Continue
Refer to VERIFICATION