Checking The Wiring And Component
WARNING:
Before fault-tracing can begin, the engine cooling fan (FC) connector must be disconnected to prevent the engine cooling fan (FC) engaging. Diagnostic trouble code (DTC) ECM-6120 Engine cooling fan (FC) control module may be stored. After fault-tracing the connector must be reconnected.
Check the resistance of the engine coolant temperature (ECT) sensor.
Check the signal cable between control module terminal #A4 (#A4) and engine coolant temperature (ECT) sensor terminal #1. Check for a short-circuit to ground.
Remedy as necessary.
Other information
- To connect the breakout box / access the control module, see CONNECTING THE BREAKOUT BOX
- For B5xx4T, see REPLACING THE THERMOSTAT AND/OR ENGINE COOLANT TEMPERATURE SENSOR
- For B6xx4T, see ENGINE COOLANT TEMPERATURE (ECT) SENSOR, REPLACING .
- For resistance values, see COMPONENT SPECIFICATIONS
- For 6 cylinder engines -2004, see SIGNAL SPECIFICATION
- For 6 cylinder engines 2005-, see SIGNAL SPECIFICATION .
- see CHECKING WIRING AND TERMINALS .
- Continue
Refer to VERIFICATION