Checking The Cable
- Ignition off.
Check the cable between the central electronic module (CEM) terminal #17D and the hazard warning signal flasher switch terminal #1 (3/6). Check for a short-circuit to ground.
Remedy as necessary.
Other information:
- For information on the central electronic module (CEM) connector:
- For -2004, see: CENTRAL ELECTRONIC MODULE (CEM), REPLACING
- For 2005-, see: CENTRAL ELECTRONIC MODULE (CEM), REPLACING .
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX
- -2004: SIGNAL SPECIFICATION
- 2005-: SIGNAL SPECIFICATION
- see CHECKING WIRING AND TERMINALS .
- For information on the central electronic module (CEM) connector:
Were any faults found?
- YES
Refer to VERIFICATION
- NO
Refer to CHECKING OVERTEMPERATURE