Checking The Wire And The Relay
- Ignition off.
Check the wire between central electronic module (CEM) 6C and relay 2/64 1 and connector 8 and 2 for a short circuit to voltage supply as described in, see OPEN-CIRCUIT, PERMANENT FAULTS .
Check that relay 2/64 is installed correctly.
Do the necessary corrective action.
Additional information:
- For information on the central electronic module (CEM) connector:
- For -2004, see: CENTRAL ELECTRONIC MODULE (CEM), REPLACING
- For 2005-, see: CENTRAL ELECTRONIC MODULE (CEM), REPLACING .
- To connect the test box, see CONNECTING THE BREAKOUT BOX .
- -2004: SIGNAL SPECIFICATION
- 2005-: SIGNAL SPECIFICATION
- For information on the central electronic module (CEM) connector:
Is there a fault?
- YES
Refer to VERIFICATION
- NO
Refer to REPLACING THE COMPONENT