Short-Circuit Between The Signal Cables
- Ignition off
- The control module for the steering wheel angle sensor disconnected
- Steering wheel module (SWM) disconnected
- Connect the breakout box to the control module for the steering wheel angle sensor and to the steering wheel module (SWM).
Check the wiring between the control module for the steering wheel angle sensor
terminal #3 (terminal (#A27) and steering wheel module (SWM) terminal #5 (terminal #A5)
terminal #4 (terminal (#A28) and steering wheel module (SWM) terminal #3 (terminal #A3)
terminal #10 (terminal (#A34) and steering wheel module (SWM) terminal #2 (terminal #A2)
#11 (#A35) and steering wheel module (SWM) #17 (#A17)
check for a short-circuit to each other.
Try replacing the steering wheel angle sensor if no faults are found in the wiring between the control module for the steering wheel angle sensor and the steering wheel module (SWM).
Other information:
- To connect the breakout box to the control module for the steering wheel angle sensor, see CONNECTING THE BREAKOUT BOX TO THE STEERING ANGLE SENSOR
- To connect the breakout box to the steering wheel module (SWM), see CONNECTING THE BREAKOUT BOX
- To replace the steering wheel angle sensor, see CONTACT REEL, REPLACEMENT
- For information about signals for the control module for the steering wheel angle sensor, see SIGNAL DESCRIPTION, CONTROL UNIT FOR THE STEERING WHEEL ANGLE SENSOR (SAS)
- For information about signals to the steering wheel module (SWM), see SIGNAL SPECIFICATION .
- Continue
Refer to VERIFICATION