Checking The Component And Wiring

Fig 1: Identifying Ignition OFF

GLL101045

Courtesy of VOLVO CARS CORPORATION

Fig 2: Disconnecting Connector

GLL101071

Courtesy of VOLVO CARS CORPORATION

Ignition off
Disconnect the connector for the flame sensor.
Check the terminals. Check for contact resistance. Check for loose connections. Check for oxidation.

Check the cable between control module terminal #1 and the flame sensor terminal. Check for an open-circuit. Check for a short-circuit to supply voltage.

Check the cable between control module terminal #2 and the flame sensor terminal. Check for an open-circuit. Check for a short-circuit to supply voltage.

Remedy as necessary.

Other information
- see COMPONENT SPECIFICATION
- see SIGNAL SPECIFICATION
- see FLAME SENSOR FUEL-POWERED PREHEATER
- see CONTENTS
Fig 3: Identifying 14-Pin Connector
Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Flame Sensor
Courtesy of VOLVO CARS CORPORATION

Continue
Refer to VERIFICATION