Faulty Signal (2007): Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

• Ignition off
• Reinstall the connectors, components etc.

  Check as follows 

  • Click on the VCT2000 symbol.

    Check that the status of the ignition switch corresponds to all key positions.

    Compare with table in link below.

  Other information 

  • For table, see:

    DESCRIPTION OF SWITCH FOR START CONTROL UNIT (SCU)

  Fig 1: Identifying VCT2000 Diagnostic Tool Symbol In VIDA (Volvo Scan Tool)

  Courtesy of VOLVO CARS CORPORATION

Are all key positions OK? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to INFORMATION