Checking The Component And Wiring

Check the signal cable for the relay for the electric engine block heater. Check between accessory electronic module (AEM) terminal #B5 and the connector for the relay. Check for a short-circuit to supply voltage. Check for an open-circuit.

Check the ground lead for the relay for the electric engine block heater. Check between accessory electronic module (AEM) terminal #B4 and the connector for the relay. Check for an open-circuit.

Remedy as necessary.

Other information: 

• see CONNECTING THE BREAKOUT BOX
• see ACCESSORY CONTROL MODULE (AEM)
• see SIGNAL SPECIFICATION
• see RELAY ELECTRICAL ENGINE BLOCK HEATER, REPLACING
• see CHECKING WIRING AND TERMINALS

Fig 1: Accessory Electronic Module Ground Terminals

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION