Signal Too High / Signal Too Low: Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS CORPORATION

Fig 2: Checking Connector

Courtesy of VOLVO CARS CORPORATION

• Ignition off
• Reconnect the connectors, reinstall components etc.
• Start the engine. The fault has not been remedied if the engine does not start.

  Read off the diagnostic status and fault status for the diagnostic trouble code (DTC) by selecting the relevant diagnostic trouble code (DTC) from the list.

  Increase the engine speed to 2500 RPM until the diagnostic is "Complete".

  Check the fault status for the diagnostic trouble code (DTC) when the diagnostic is "Complete". If the function is correct, the fault status must be "No fault found" when the diagnostic is complete.

  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA (Volvo Scan Tool)

  Courtesy of VOLVO CARS CORPORATION

Is the function OK? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to INFORMATION