Checking The Status

Fig 1: Engine Start Verification

GLL101037

Courtesy of VOLVO CARS CORPORATION

Start the engine.
Read off the diagnostic status and fault status for the diagnostic trouble code (DTC) by selecting the relevant diagnostic trouble code (DTC) from the list.

Increase the engine speed to 2500 RPM until the diagnostic is "Complete".

Check whether the fault is permanent or intermittent. Read off the diagnostic trouble code (DTC) fault status when the diagnostic status is "Completed".

HINT: In some cases several functions of the component will be diagnosed. This affects the amount of time taken to run the diagnostic.

The fault is permanent if the fault status is "Fault found". If the fault status is "No fault found" the fault is intermittent and not presently active.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA (Volvo Scan Tool)
Courtesy of VOLVO CARS CORPORATION

Fig 3: Camshaft Position Sensor
Courtesy of VOLVO CARS CORPORATION

Continue
Refer to CHECKING COMPONENTS AND WIRING