Checking The Wiring And Component

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS CORPORATION

• Ignition off.

  Check the communication cable between gear selector control module terminal #2 and transmission control module (TCM) terminal #B31 (#B21). Check for an open-circuit. See OPEN-CIRCUIT, PERMANENT FAULTS .

  Replace the circuit board in the top panel if no fault is found in the cable.

  Remedy as necessary.

  Other information: 

  • To connect the breakout box, see CONNECTING THE BREAKOUT BOX
  • To replace the circuit board in the top panel (standard), see PRINTED CIRCUIT BOARD GEAR SELECTOR ASSEMBLY/TOP PANEL, REPLACING
  • To replace the circuit board in the top panel (Geartronic), see PRINTED CIRCUIT BOARD GEAR SELECTOR ASSEMBLY/TOP PANEL GEARTRONIC, REPLACING
  • For information about signals, see SIGNAL DESCRIPTION. TRANSMISSION CONTROL MODULE (TCM) .
  Fig 2: Identifying Breakout Box

  Courtesy of VOLVO CARS CORPORATION
  Fig 3: Identifying Ohms Display

  Courtesy of VOLVO CARS CORPORATION

Was a fault detected? 

• YES 

  Refer to VERIFICATION 

• NO 

  FAULT NOT FOUND:  Troubleshooting has been completed.