Checking The Component

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS CORPORATION

Fig 2: Disconnecting Connector

Courtesy of VOLVO CARS CORPORATION

• Switch off the ignition. Wait 10 seconds
• Disconnect the connector from the left-hand inflatable curtain
• Disconnect the connectors from the supplemental restraint system module (SRS).
  WARNING:

  Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected non-deployed seat belt tensioner. The seat belt tensioner could deploy

  CAUTION:

  Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).

  Check the connectors for the inflatable curtain and the supplemental restraint system module (SRS). Check for damage to pins and terminals in the connectors. Also check the wiring.

  Remedy as necessary.

  Check that the correct supplemental restraint system module (SRS) is installed in the car.

  • Connect the connector to the left-hand inflatable curtain
  • Connect the connectors for the supplemental restraint system module (SRS)
  • Switch on the ignition. Wait 10 seconds
  • Read off by clicking the VCT2000 symbol.

  If no fault is found, replace the control module.

  Other information 

  • see SIGNAL SPECIFICATION
  • To access or replace the supplemental restraint system module (SRS) and the connectors. See: AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (2005-2007) or AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (2008-2011)
  • To access/replace collision curtain and connectors:

    see INFLATABLE CURTAIN (2005-2007) , or INFLATABLE CURTAIN (2008-2011)

  • see CHECKING WIRING AND TERMINALS
  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

Select "Continue" when the fault has been remedied. 

• Continue 

  see VERIFICATION