Signal Too High / Signal Missing / Faulty Signal: Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied.

Fig 1: Engine Start Verification

Courtesy of VOLVO CARS CORPORATION

Fig 2: Connecting Connector

Courtesy of VOLVO CARS CORPORATION

Ignition off
Reconnect the connectors, reinstall components etc.
Test drive the car at an even speed (engine speed (RPM) above 2000 RPM) for at least 5 minutes
Release the accelerator pedal (AP) quickly at least three times to simulate fuel shut-off
Connect VCT2000 or appropriate scan tool to the data link connector (DLC) without switching off the engine.
NOTE:
If the engine is switched off, the stored fault status will be erased and the test drive will have to be repeated.

Read off the diagnostic status and fault status for the diagnostic trouble code (DTC) by selecting the relevant diagnostic trouble code (DTC) from the list.

Check the fault status for the diagnostic trouble code (DTC) when the diagnostic is "Complete". If the function is correct, the fault status must be "No fault found" when the diagnostic is complete.

Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS CORPORATION

Is the function OK?