Faulty Signal (2007): Verification: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Identifying Engine START Position

Courtesy of VOLVO CARS CORPORATION

Fig 2: Checking Connector

Courtesy of VOLVO CARS CORPORATION

• Ignition off
• Reinstall the connectors, components etc.

  Check that the starter motor is running when the ignition switch is in position 3 (starting position).

  Leave the ignition switched off for at least 10 minutes. Then check that the diagnostic trouble code (DTC) has not recurred.

Is the function OK? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to INFORMATION