Signal Specification

All the values given below are between the respective terminal in column 1 and terminal #A5 in column 2 (power ground) unless otherwise stated in brackets after the table entry.

U=	DC voltage in volts (V)	Ulow =	Voltage approximately 0 V
Ubat =	Battery voltage (V)	-	-

Connector A 

Control module terminal	Signal type	Ignition on	Other
#A1	30-feed	U = Ubat	Power supply
#A2	-	-	-
#A3	-	-	-
#A4	-	-	-
#A5	Ground	U= Ulow	-

Connector B 

Breakout box terminal	Control module terminal	Signal type	Ignition on	Other
#1	#B1	Color signal (red), screen	Analog signal when a red color signal is used	0.714 Vp-p
#2	#B2	Color signal (green), display	Analog signal when a green color signal is used	0.714 Vp-p
#3	#B3	-	-	-
#4	#B4	Remote control, signal from display screen to Multimedia module (MMM)	-	-
#5	#B5	-	-	-
#6	#B6	Color signal (blue), screen	Analog signal when a green color signal is used	0.714 Vp-p
#7	#B7	Screen ground video signals	Ulow	-
#8	#B8	RGB-synch, display screen	Analog signal	0-5 V
#9	#B9	-	-	-
#10	#B10	Video signal, display screen	Analog signal	1 Vp-p ± 0.2V
H	-	Screen ground	-	-

Connector C 

Control module terminal	Signal type	Ignition on	Other
#C1	MOST input signal	-	Optical input signal
#C2	MOST output signal	-	Optical output signal

Connector D 

Control module terminal	Signal type	Ignition on	Other
#D1	GPS signal	-	Antenna signal
#D2	Screen	-	-

Connector E 

Control module terminal	Signal type	Ignition on	Other
#E1	FM signal in (TMC)	-	Antenna signal
#E2	FM signal out (TMC)	-	Antenna signal