Checking The Component And Wiring

Check the microphone signal cable at control module connector A. Check for a short-circuit to supply voltage.

Check between:

• terminals #19 (#19) and #7 (#7)
• terminals #19 (#19) and #5 (#5).

Check the cable for the microphone signal. Check for an open-circuit.

Take a reading between control module connector terminal A#19 (#19) and handset connector terminal #1 (#21).

Check the connectors for loose connections, damaged or bent terminal pins and oxidation.

Try replacing the carphone handset or holder if no fault is found in the cable.

Remedy as necessary.

Other information: 

• see SIGNAL SPECIFICATION
• see CONNECTING THE BREAKOUT BOX
• see LOCATION OF COMPONENTS
• see PHONE MODULE (PHM) (2005-2011)
• see TELEPHONE HANDSET (2005-2011)
• see CONTENTS

Fig 2: Identifying Connector A Terminals

Courtesy of VOLVO CARS CORPORATION

Fig 3: Identifying Ohms Display

Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Handset Cradle

Courtesy of VOLVO CARS CORPORATION

Refer to VERIFICATION