Checking Components And Wiring
Check the signal cable between engine control module (ECM) terminal #A47 (#A47) and camshaft position (CMP) sensor connector terminal #3. Check for a short-circuit to ground.
Check the power cable between engine control module (ECM) terminal #A29 (#A29) and camshaft position (CMP) sensor connector terminal #1. Check for an open-circuit.
HINT: With the ignition on and the camshaft position (CMP) sensor connector disconnected, the voltage between terminal #1 and ground terminal should be approximately 5 V.
Remedy as necessary.
Other information
- see CONNECTING THE BREAKOUT BOX
- For 5 cylinder turbocharged engines -2004, see SIGNAL DESCRIPTION
- For 5 cylinder turbocharged engines 2005-, see SIGNAL SPECIFICATION .
- see POSITION SENSOR CAMSHAFT, REPLACING
- see CHECKING WIRING AND TERMINALS
- Continue
Refer to VERIFICATION