Intermittent Fault

If the car is equipped with a 10-pin connector

Check the cable between control module terminal #14A and power door mirror terminal #1. Check for an intermittent short-circuit to ground.

If the car is equipped with a 16-pin connector

Check the cable between control module terminal #14A and power door mirror terminal #2. Check for an intermittent short-circuit to ground.

Replace the outside temperature sensor if no fault is found.

Other information:

To connect the breakout box, see CONNECTING THE BREAKOUT BOX
For further information about signals and other values, see SIGNAL SPECIFICATION
To access the connector for the power door mirror, see REAR VIEW MIRROR, REPLACING
Outside temperature sensor -2006, see OUTSIDE TEMPERATURE SENSOR DOOR MIRROR, REPLACING
Outside temperature sensor 2007-, see OUTSIDE TEMPERATURE SENSOR
see CHECKING WIRING AND TERMINALS .

Fig 1: Identifying 10--Pin Power Door Mirror Connector Terminal

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS CORPORATION

Fig 3: Connector, Green (16- Pin)

Courtesy of VOLVO CARS CORPORATION