PHM-U210909: Back-Up Battery. General Failure Information. Component Failures (2008-09): Fault-Tracing: Verification
HINT: After carrying out the repair, check that the fault has been remedied.
- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
So that the DTCs test can run correctly, the following sequence must be gone through.
- Drive the vehicle out of the workshop and allow the vehicle to stand a while with the engine running, so that the Phone module (PHM) has time to receive a GPS position.
- Drive the vehicle back into the workshop.NOTE: Do not remove the remote key from the start control module (SCU).
- Click the VCT2000 symbol and follow the instructions there.
Check that the diagnostic trouble code has disappeared or changed status to intermittent.
Is the carphone working?
- YES
OKAY: Troubleshooting has been completed.
- NO
Refer to INFORMATION