Diagnostic Trouble Code (DTC) Information BCM-U200746
Condition
The brake control module (BCM) with hydraulic unit supplied calibrated from the factory.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Calibration not completed
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.
NOTE:
The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.
Substitute Value
- Stability control blocked.
- Traction control blocked.
- Active yaw control (AYC) is blocked.
HINT: BRAKE SYSTEM, ABBREVIATIONS
Possible Source
- Fault-trace the central electronic module (CEM).
NOTE:
This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.
Fault symptom[s]
- ABS warning light on
- General warning lamp lit
- Stability function is not working
- Traction control not working
- Anti skid function is not working