TCM-P089468: Transmission Component Slipping. Algorithm Based Failures. Event Information (B6304T2, TF-80SC AWD; B6324S, TF-80SC AWD; 2008-2009): Fault-Tracing: Verification: Verification

NOTE:

When the transmission's control module has been removed and reinstalled, it is important that the gear position sensor is calibrated. Select Pause and create a bookmark. Then select Vehicle communication.

HINT: After carrying out the repair, check that the fault has been remedied.

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS CORPORATION

Ignition off.
Reinstall the connectors, components etc.
Test drive the vehicle following: TEST DRIVE SCHEDULE, DESCRIPTION
Check that the transmission does not display any obvious function faults.

NOTE:
When test driving, the oil temperature must be above 20 °C.

Is the function OK?

YES
VERIFIED: Troubleshooting has been completed.
NO
Refer to INFORMATION