Checking Components And Wiring

Check the connector for the camshaft position (CMP) sensor. Check for contact resistance and oxidation.

Check the signal cable between engine control module (ECM) terminal #A61 (#B1) and camshaft position (CMP) sensor connector terminal #3. Check for an open-circuit. Check for a short-circuit to ground.

Check the power cable between engine control module (ECM) terminal #A13 (#A13) and camshaft position (CMP) sensor connector terminal #1. Check for an open-circuit.

Remedy as necessary.

Other information 

• see CONNECTING THE BREAKOUT BOX
• see SIGNAL SPECIFICATION
• see CAMSHAFT POSITION SENSOR (CMP)
• see CHECKING WIRING AND TERMINALS

Fig 1: Identifying 3-Bit Connector

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

Courtesy of VOLVO CARS CORPORATION

Fig 3: Detecting Camshaft Flanks On Sensor

Courtesy of VOLVO CARS CORPORATION

• Continue 

  Refer to VERIFICATION