Diagnostic Trouble Code (DTC) Information ECM-P261087

Condition 

Central electronic module (CEM) sends information via the CAN-net about how long time has passed since the engine was turned off the last time. Engine control module (ECM) receives the signal and compares it to own calculated time (calculated based on temperature changes of engine temperature and outdoor temperature).

If Engine control module (ECM) does not receive any time from Central electronic module (CEM), the diagnostic trouble code is generated.

The diagnostic trouble code can be diagnosed when the ignition is on.

Substitute Value 

• The calculated time is used.

Possible Source 

• Malfunction detected by central electronic module (CEM).
• Open-circuit in the control area network (CAN) wiring.
• Short-circuit between the control area network (CAN) wiring.
• Internal malfunction in central electronic module (CEM).
• Internal fault in the engine control module (ECM).
• Internal fault in another control module in the same part of the control area network (CAN).

Fault symptom[s] 

• Nothing.