Diagnostic Trouble Code (DTC) Information BCM-C007268

Condition

The Brake control module (BCM) registers how much the brakes have been used and then calculates the temperature on all brake discs.

The diagnostic trouble code (DTC) is stored if the control module detects that:

The calculated temperature exceeds 450 °C.

The control module's test for the diagnostic trouble code (DTC) starts in the event of:

Ignition switch position II.

NOTE:

The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute Value

Traction control blocked.

HINT: BRAKE SYSTEM, ABBREVIATIONS

Possible Source

Traction control too long.
Brakes applied too long (brakes have been used so much that brake disc temperature has become too high).

NOTE:

This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]

Anti-spin warning lamp lit