Diagnostic Trouble Code (DTC) Information BCM-C006A01

Condition

The Body sensor cluster stability sensor (BSC) is supplied with 12 V. Brake control module (BCM) is supplied with voltage when the ignition is on. The stability sensor is supplied with power after the control module has checked if there is voltage in the cable.

The diagnostic trouble code (DTC) is stored if the control module detects that:

The voltage is high but the Brake control module (BCM) does not have a power supplied sensor.

The control module's test for the diagnostic trouble code (DTC) starts in the event of:

Ignition switch position II.

NOTE:

The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Fig 1: Identifying Lateral Acceleration Sensor

Courtesy of VOLVO CARS CORPORATION

Substitute Value

Traction control blocked.
Stability control blocked.
Active yaw control (AYC) is blocked.

HINT: BRAKE SYSTEM, ABBREVIATIONS

Possible Source

Contact resistance or oxidation in the terminals.
Short-circuit to supply voltage in the cable.
Short-circuit to ground in the cable.
Open-circuit in the cable.
Internal fault in the body sensor cluster (BSC).

NOTE:

This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]

Anti-spin warning lamp lit
Stability function is not working
Traction control not working
Anti skid function is not working
Adaptive cruise control; No Functionality
Collision avoidance driver support; No Functionality
Front monitoring/Active safety/City Safety does not work