Diagnostic Trouble Code (DTC) Information

Condition

The driver/passenger door module (DDM/PDM) both sends and receives information via a standardized serial communication method - LIN (Local Interconnect Network). The following components communicate on LIN bus 2:

Left/right camera module (LCM/RCM).

The diagnostic trouble code (DTC) is stored if the control module detects that:

Signal missing.

The control module's test for the diagnostic trouble code (DTC) starts in the event of:

Control module supplied with power.

NOTE:

The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Fig 1: Identifying Driver Door/Passenger Door Module (DDM/PDM)

Courtesy of VOLVO CARS CORPORATION

Substitute Value

None.

Possible Source

Open-circuit in the communication cable.
Short-circuit to ground in the communication cable.
Short-circuit to supply voltage in the communication cable.
Contact resistance or oxidation in the terminals.
Open-circuit in terminals.
Short-circuit in connections.

Fault symptom[s]

LED does not light