Section 194 (Gearshift Position Sensor, Side Cover, And Control System Solenoids - Removal And Installation)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission
- Gear-shift position sensor, replacing (AW50/51 AWD; AW55-50/51SN)
- Preparations
- Remove the air cleaner (ACL) housing
- Remove the transmission cable from the bracket and the lever from the transmission
- Remove the gear-shift position sensor
- Remove the connector from the transmission
- Separate the connector on the transmission
- Detach the socket for the gear-shift position sensor
- Assemble the connector
- Connect the connector to the transmission
- Install the gear-shift position sensor
- Adjust the gear-shift position sensor
- Continued gear-shift position sensor installation
- Install the transmission cable on the transmission
- Install the air cleaner (ACL) housing
- Checking diagnostic trouble codes (DTCs)
- Gear-shift position sensor, replacing (AW55-50 1999)
- Notes
- Replacing the gear-shift position sensor
- Removing engine compartment components
- Removing the gearbox cable
- Removing the gear-shift position sensor
- Removing the connector from the gearbox
- Disassembling the connector on the gearbox
- Assembling the connector
- Installing the connector on the gearbox
- Installing the gear-shift position sensor
- Adjusting the gear-shift position sensor
- Installing the gear-shift position sensor, continued
- Installing the gear selector cable
- Installing engine compartment components
- Checking the diagnostic trouble codes (DTCs)
- Replacing the three-way catalytic converter (TWC)
- Side cover transmission, replacing
- Solenoids, control system, replacing
- Notes
- Solenoids, control system, replacing (AW50-42 1999)
- Notes
- Removal
- Preparations
- Remove the terminal from the transmission
- Install the lifting beam and lifting hook
- Raise the car
- Removing the right-hand drive shaft
- Remove the screws for the cable conduit and the ground lead bracket on the sub-frame
- Remove the ball joint nuts (both sides)
- Remove the bracket for the power supply cable to the heated oxygen sensor (HO2S) from the sub-frame
- Disconnect the steering gear from the sub-frame
- Remove the screws for the sub-frame support brakes, both sides
- Lower the sub-frame
- Drain the transmission oil
- Remove the control system cover
- Checking the solenoids
- Information, versions and combinations
- Reinstall the control system
- Assembling the control system
- Solenoids, control system, replacing (AW55-50 -2000)
- Splines, greasing
- Gear-shift position sensor, replacing (AW50/51 AWD; AW55-50/51SN)