Checking The Transmission Connectors

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Ignition OFF

GLL101045

Courtesy of VOLVO CARS CORPORATION

Ignition off
Remove the gear selector connector.
Check the connector (gear selector assembly). Check for bent or pressed in pins.

Check the power supply cable between gear selector module (GSM) terminal #1 and transmission control module (TCM) terminal #16 (#A46). Check for an open-circuit. Check for a short-circuit to ground.

Remedy as necessary.

Other information
- To remove the gear selector's connector, see TOP PANEL GEAR SELECTOR ASSEMBLY
- see CONTENTS
- see SIGNAL SPECIFICATION
Fig 2: Identifying Ohms Display
Courtesy of VOLVO CARS CORPORATION

Continue
Refer to VERIFICATION