Checking Cable And Component

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Ignition OFF

GLL101045

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Connector(s) Reinstallation

GLL101069

Courtesy of VOLVO CARS CORPORATION

Ignition off
Expose the transmission control system.
Check connector C (22-pin) for the transmission control module (TCM). Check for contact resistance. Check for oxidation.

Check the cable between transmission connector terminal #C13 and the temperature sensor. Check the cable between transmission connector terminal #C14 and the temperature sensor. Check for an open-circuit. Check for a short-circuit to supply voltage. Also check the cables for a short-circuit to each other.

HINT: Check the temperature sensor by taking a reading of the resistance between terminals #C13 and #C14 with the ignition off, the transmission connector C (22-pin) disconnected and the breakout box connected. For the resistance values, see below.

Remedy as necessary.

Other information
- see TRANSMISSION CONTROL MODULE (TCM)
- see COVER, CONTROL SYSTEM
- see SIGNAL SPECIFICATION
- see COMPONENT RESISTANCE VALUES
- see CONTENTS
Fig 3: Identifying Transmission Control Module Connector
Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Ohms Display
Courtesy of VOLVO CARS CORPORATION

Fig 5: Identifying Oil Temperature Sensor
Courtesy of VOLVO CARS CORPORATION

Continue
Refer to RESETTING THE TRANSMISSION FLUID CHANGE COUNTER