Diagnostic Trouble Code (DTC) Information
WARNING: This page is about a different variant/trim than selected.
Condition
The transmission control module (TCM) receives a signal about input and output speed from the transmission rpm and speed sensor. There is a specific ratio for each gear, and using the signals the control module calculates the transmission gear ratio. Diagnostic trouble code (DTC) TCM-0028, TCM-0029, TCM-002A, TCM-002B or TCM-002C (depending on fault cause) is stored if the transmission control module (TCM) registers that the gear ratio deviates by more than 10%.
The diagnostic trouble code (DTC) can be diagnosed at an oil temperature of above +20 °C in the transmission and for:
- TCM-0028 Gear 1 and engine speed (RPM) above 500 but below 1260 rpm, as well as throttle opening greater than 50% and gear ratio = 2.301 +/- 4%
- TCM-0029 Gear 2 and engine speed (RPM) above 500 rpm, as well as throttle opening greater than 10% and gear ratio deviation greater than 20%
- TCM-002A Gear 3 and engine speed (RPM) above 500 rpm, as well as throttle opening greater than 10% and gear ratio deviation greater than 20%
- TCM-002B Gear 4 and engine speed (RPM) above 500 rpm, as well as throttle opening greater than 10% and gear ratio deviation greater than 20%
- TCM-002C Gear 5 and engine speed (RPM) above 500 rpm, as well as throttle opening greater than 10% and gear ratio deviation greater than 20%.
Substitute Value
- Emergency program Emergency mode 1 in the transmission control module (TCM) has been initiated.
HINT: EMERGENCY MODE IN THE EVENT OF A FAULT
Possible Source
- Contact resistance in the circuit for the solenoids. See the table below:
Gear/diagnostic trouble code (DTC) Circuit for solenoid 1/TCM-0028 S1 2/TCM-0029 S3 3/TCM-002A S3, S4 4/TCM-002B S4 5/TCM-002C S2, S4 - One of the shift solenoids has jammed in the OFF or ON position. See the table below:
Gear/diagnostic trouble code (DTC) Solenoid jammed in the OFF position Solenoid jammed in the ON position 1/TCM-0028 S1 S4, SLT 2/TCM-0029 S3 S1, S2, S4, SLT 3/TCM-002A S3, S4 S1, S2, S5, SLT 4/TCM-002B S4 S1, S2, S3, S5, SLT 5/TCM-002C S2, S4 S3, S5, SLT - Mechanical fault in the transmission. Worn components in the transmission causing slippage or too low line pressure.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit
- General warning lamp lit
- Abnormal slipping gear shifting
- Harsh gear shifting
- No shifting.