Checking The Wiring And Component

Check connector C (22-pin) for the transmission control module (TCM). Check for contact resistance. Check for oxidation.

Check the cable between transmission connector terminal #C2 and the connector for solenoid S2. Check for a short-circuit to ground.

HINT: Check solenoid S2 by taking a reading of the resistance between the solenoid connector and ground with the ignition off, the transmission connector C (22-pin) disconnected and the breakout box connected. For the resistance values, see below. 

Other information 

• see CONNECTING THE BREAKOUT BOX
• To disconnect the transmission connectors, see TRANSMISSION CONTROL MODULE (TCM)
• see TRANSMISSION CONTROL MODULE (TCM)
• see TEMPERATURE SENSOR FLUID, TRANSAXLE, (TFT) (TURBO)or TEMPERATURE SENSOR FLUID, TRANSAXLE, (TFT) (NON-TURBO)
• see SIGNAL SPECIFICATION
• see TRANSMISSION CONTROL UNIT SOLENOIDS
• see COMPONENT RESISTANCE VALUES
• see CONTENTS

Fig 3: Identifying Transmission Control Module Connector

Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Ohms Display

Courtesy of VOLVO CARS CORPORATION

Fig 5: Identifying Shift Solenoids S1, S2, S3, S4 And S5

Courtesy of VOLVO CARS CORPORATION

Refer to RESETTING ADAPTATION