Adaptation Of The Throttle Unit

HINT: Faults which cause this diagnostic trouble code (DTC) may affect the adaptation values for the throttle unit. Carry out adaptation of the throttle unit to update the adaptation values.

NOTE:

The ignition must be switched on for at least 30 seconds after the basic conditions are met in order for the adaptation to start. It takes approximately 10 seconds to run the adaptation.

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

Fig 2: Checking Connector

Courtesy of VOLVO CARS CORPORATION

Ignition off
Reinstall the components and connectors etc.
Ignition on.
Read off parameters.

Check that the following basic conditions for adaptation of the throttle unit are met.
1. Ignition on / engine off
2. Battery voltage above 10 V
3. Accelerator pedal (AP) unaffected
4. The vehicle must be stationary (no vehicle speed signal)
5. Engine coolant temperature (ECT) between 5-100 °C
6. Intake air temperature (IAT) above 5 °C.
Remedy as necessary.

Check that the adaptation is correctly run after the "Adaptation of the throttle unit running" parameter changes status from "YES" to "NO". When all basic conditions are met, the adaptation must be completed after approximately 40 seconds. When the adaptation is completed correctly, the following information will be displayed:
- Adaptation of the throttle unit: OK
- Adaptation of the throttle unit running: NO.
Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS CORPORATION

Fig 4: Identifying Throttle Unit & Potentiometer
Courtesy of VOLVO CARS CORPORATION

Continue without switching off the ignition when the adaptation is OK.
Refer to CHECKING THE FUNCTION