Diagnostic Trouble Code (DTC) Information ECM-310A
Condition
The engine control module (ECM) counts the number of teeth on the flywheel / carrier plate using the engine speed (RPM) sensor signal. The diagnostic trouble code (DTC) for an intermittent fault is stored if an incorrect number of teeth are detected during a set number of crankshaft revolutions. The diagnostic trouble code (DTC) for a faulty signal is stored if the fault is detected during several consecutive operating cycles.
The diagnostic trouble code (DTC) can be diagnosed when the engine speed (RPM) is higher than approximately 1000 RPM.
Substitute Value
Signal from camshaft position (CMP) sensor.
Possible Source
- Contact resistance or oxidation in the engine speed (RPM) sensor connector
- Incorrectly installed engine speed (RPM) sensor
- Damage to carrier plate / flywheel
- Damaged engine speed (RPM) sensor.
Fault symptom[s]
- None.