Checking The Component

WARNING:

Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected non-deployed adaptive steering column. The adaptive steering column could deploy

Fig 1: Identifying Ignition In Off Position

Courtesy of VOLVO CARS CORPORATION

Fig 2: Identifying Microphone Connectors

Courtesy of VOLVO CARS CORPORATION

Ignition off, wait for 15 seconds.
Disconnect the connector from the adaptive steering column.
Attach a special tool to the connector (to the ignition cable). To carry out this procedure, use: see 9511506
NOTE:
The special tool must be checked and fault-free. If the special tool is faulty, the diagnostic readings will be incorrect. This will make fault-tracing harder.

Other information
- see STEERING COLUMN
- Checking the special tool: see CALIBRATION
Switch on the ignition. Wait 10 seconds.
Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.
- If the diagnostic trouble code (DTC) is permanent:
  Refer to CHECKING THE WIRING AND TERMINALS
- If the diagnostic trouble code (DTC) is intermittent:
  Refer to REPLACING A COMPONENT
Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA (Volvo Scan Tool)
Courtesy of VOLVO CARS CORPORATION